At a flange with barely two inches of clearance, the wrong tool can stop a crew cold.
Industrial Bolting builds
RAD torque gun rentals around the tool, reaction point, and power source that actually match the joint. We ask about access, torque targets, and power needs before equipment leaves our shop. A quick call early on can save hours once the bolts are in front of you.
Rental Setups Built for Tight Work Areas
Six inches of swing room may be enough for one reaction arm and useless for another. We build each rental around the space on site, then set up a
RAD torque gun with a drive and reaction arrangement suited to that area. Battery, pneumatic, and electronic torque tools are all available for controlled bolting work. The goal stays simple: get the required torque on the fastener without crowding the crew.
- Battery tools: A good fit when cords and air hoses would clutter the work area.
- Pneumatic tools: Where shop air is already available, these tools can handle repeat tightening work.
- Electronic tools: For procedures that call for recorded torque results, these units capture the tightening data.
Handling Tight-Access Bolting the Right Way
On a four-bolt pump cover, clearance can change from one fastener to the next. We look at the drive, reaction point, and power source before releasing equipment, then review the setup with your crew. That gives everyone a chance to spot clearance issues before the first tightening cycle begins.
Space Matters as Much as Torque
Raw torque is only part of the job. We also consider where the tool sits throughout the full tightening cycle, which matters most at awkward bolt locations near guards, piping, or machine frames. Sockets, reducers, reaction arms, and the room around each fastener all factor into the setup. Rather than hand over a generic equipment list, we talk through the actual work in front of you.
A Straightforward Process From Call to Handoff
A Friday outage can look very different by noon if the scope changes. We handle that with a simple process: tell us about the joint, the access conditions, and the torque requirement during our intake call, and we go over the equipment setup with your crew before work starts. If the scope shifts mid-job, we can adjust rental equipment around the bolting work still on your schedule. Industrial Bolting proudly serves crews near
Muskego, WI and throughout
Wisconsin,
Minnesota,
North Dakota, and
South Dakota. If a rented tool becomes something your crew wants to keep, we’re also happy to talk through
tool sales options. Whether the job is planned weeks out or added mid-outage,
contact us at
(888) 781-2007 to get started.